Replacing tie rods and tips

What are steering rods?

The steering rod is a part of the steering drive, a joint that connects the wheels and the steering mechanism. Its task is to transmit the steering angle to the wheels and ensure the stability of the car in turns. When the car turns, thanks to the work of the steering rod, the wheels take the correct position.

Depending on the make and model of the car, there are different types of steering rods that are included in the drive.

The main part of the steering rod is a metal rod. It can be damaged as a result of hitting an obstacle at high speed. There are three elements that can fail: the boot, the split pin, the hinges.

• The boot – as a result of the displacement of some parts, this element needs to be replaced
• The split pin – problems can arise if it is installed incorrectly
• Hinges – in case of wear of the liner or deformation of the finger surface, this component may malfunction
• Damage to the bushing or thread

The signs of this are easy to notice even for a novice driver. If it is difficult to turn the steering wheel, there is a knock in the steering wheel or you notice an increase in play – this indicates that the steering rod is faulty.

It is very important to regularly diagnose the suspension, as this will help determine the condition of the steering rod and repair or replace it in time.

Causes of steering linkage failure:

• Corrosion (first the steering tip is destroyed, and then it passes to the linkages);
• The car is driving at high speeds, and this can cause deformation of certain parts;
• Damage to the boot;
• Broken cotter pin.

You need to be as careful as possible, as all of these reasons affect the car’s handling. The likelihood of a camber-toe failure also increases, so after repairing or replacing the steering linkage, it is recommended to adjust it.

We provide steering linkage replacement services quickly, efficiently and at a reasonable price. To prevent further malfunctions, especially reduced car handling, if you detect any problems, promptly contact the MB Master car service. Our craftsmen will select the necessary parts and do everything possible to ensure your comfort while driving.

When you need to replace the steering tip:

• A knock in the front of the car or a banging on the steering wheel when the car turns at high speed or brakes sharply;
• Scratching when driving off-road;
• Increased steering wheel play;
• Poor vehicle handling.

Main areas of responsibility of the steering tip:

• correct entry into the turn;
• preserving steering and wheels when the car hits bumps or potholes.

Replacing the steering tie rod end

Replacing the steering tie rod end of a car is usually done as a set. Firstly, the elements located on both wheels are changed. Secondly, the right decision would be to replace the rods as well. The fact is that they have approximately the same service life. Therefore, in order not to return to servicing this unit, purchase spare parts in a set. It is also worth inspecting the condition of the anthers – if the material of the elements is defective, install new protective covers. Main stages:

• Procedure for disconnecting the thrust from the knuckle
• Removing the anther
• Procedure for disconnecting the thrust from the rail
• Removing the tip
• Installing a new part
• Connecting and installing the anther
• After performing these operations, it is necessary to install the camber-toe adjustment. Otherwise, it will be impossible to achieve the car’s normal behavior.

It is recommended to change the tips in pairs. Most often, the steering rods are also changed together with them, so as not to disassemble the assembly twice and save on the cost of work. When replacing the tips and steering rods, there is a possibility of damaging the rack. Therefore, it is better not to perform this repair without special skills. Our service staff, using special pullers and torque wrenches, will carefully replace the suspension elements without damaging the steering rack crumb.

Purpose of steering rod tips

Steering tips are responsible not only for the correct operation of the steering system, but also for the correct angle of the wheels when turning. The steering mechanism includes the following parts: